FREE SHIPPING AND READY TO SHIP!


SAME AS OUR DELUX KIT BUT WITH A SMALLER POWER SUPPLY.

GREAT FIRST KIT OR LOW COST SECOND KIT

This 2 AMP power supply is a really good starter size and can elecrtoform 2 rings, a pair of earrings or a medium sized leaf at a time. Most starter sets that I see are 1 AMP and 1 Liter, this set is 2 amps and 1.5 liters, so you'll have a bigger capacity to start with compared to other sets. Plus it comes with advanced freatures such as a magnetic stirrer, anti corrosion titanium hardware and a titanium anode cage, saving you hours of time giving you even better results! It can plate an item that is 10 - 15 square inches of surface area. For the price it is a really good deal. This power supply is also good for brush plating.

Bring Your Electroform Kit to the next level, get more consistent results. If you purchase this all you will have to supply is sulphuric acid to start electroforming.


Kit Includes:


Hardware

1.5 liter container
POWER SUPPLY
Power Adapter
ANODE CAGE
Anode Cage Bag
MAGNETIC STIRRER
Stir bar
TITANIUM Bus Bar
Bus Bar Brackets
Cathode Clips
Heavy Duty Power Leads
copper test squares
syringe for dosing chloride and lustro Smooth-O
Coffee Filters
Copper Sulphate
BRIGHTENER
LUSTRO ELECTRO SUPER BRIGHT. Part A- Red Label – BRIGHTENER
LUSTRO SMOOTH-O MINI Trial Size Part B – Carrier & Leveling agent.
Chloride
Sulphur for making patina

You will need to supply Sulphuric acid.
If you need help sourcing sulphuric acid contact me



FREE Support

Formula for conductive paint
Formula and instructions for electroform solution
Chloride Dosing Instructions
Advice on set and where to get othert items that are needed locally
Electroform Knowledge Club Newsletter

Preparation Of Brightener

Add 50ML heated ( hot but not nearly boiling) distilled water to bottle, replace cap, and shake well until all solids are dissolved.

FOR BEST RESULTS PLEASE DO NOT FILL BOTTLE ONLY ADD 50ML DISTILLED WATER.

Whole batch must be made at same time other wise it will not work properly.

Start by Adding 5 drops per liter to copper sulfate based electroforming solution and then testing. The exact amount needed will be determined by your baths make up. Our customers have reported 5-10 drops per liter were used, start at 5 and work your way up. My baths use between 5-6 drops. Current setting can range from .1A/ in2- .3A/ in2 depending of electroformed project and the composition of your bath. Start low and slowly increase current until bright and shiny surface develops.
Do not mix with other brighteners or leveling agents as they may not be compatible.

For this brightener to work properly chloride is needed in the bath, the easiest way to do this is watch our video on Chloride Dosing.